Add HIGH_SPEED_CONN Liberop script argument to select between no high
speed connector being included in the design (NONE) or including a
design stub (IO_STUB) exposing the pins used by the high speed
connector. The later being used to validate I/O pin constraints.

- Add missing cape signals.
- Adjust M.2 and base design pin constraints to match new cape pin
  assignments
- Move immutable cape signasl pin constraints to base design's pin
  constraints file.

- Remove PCM signals
- Reduce PCIe from 2 to 1 lane.

Let I/O pads propagate to the top level of the design and rename as
required.

Couple the pin constraint files with the variant of design blocks.
This should allow us to customize cape I/Os to best suit a specific
cape. It also allows to easily include or excluse a block from the
design. For example, not include cape, M.2, MIPI-CSI or high speed
interface if not required and tight on FPGA resources.

  - Adjust DDR memory layout to match the Icicle Kit's 2022.02 release
    (move to 64-bit address range).

  - Temporary removal of MIPI-CSI interface.

  - Add over-current input to MSS GPIO_1 input 23.
  - Rename USB signal names to match shcematics.

  - Add details of pins usage.
  - List all FPGA pin assignments to headers P8 and P9.

  - Add PLL to generate 4.915MHz clock for ADC_MCLK.
  - Connect ADC interrupt to MSS GPIO 1 input 20.

  - Connect Ethernet management interface to PHY.
  - Connect PHY reset input to FPGA system reset.
  - Connect PHY interrupt to MSS F2M fabric interrupt 2.

  - Removed pins reserved for probe from project options to free up
    pin C14 and C15 for use as cape pins.
  - Set pin migrations to all available devices in project settins to
    allow migration to all devices in same package.

  - Connected MMUART_4 to cape P9 connector pins 11 and 13.
  - Added pin constraints for cape P9 connector pins 11 and 13.

  - Marked pins not available in the MPFS025-FCVG484 package.
  - Identified available pins not currently used in the design.
  - Identified pins used in the design that need to be properly
    document (marked as GPIO?).