mikroBus shuttle connector is reversed
Problem
The mikroBus shuttle connector connection is reversed on BeagleV ahead DVT v0.2 board. As per mikroBus pin1 should be AN and pin 15,16 should be GND which is not how we have wired the connector as you can see in the schematic section below:
Image below shows the proper connection, you can see it here as well.
You can check the same on board, silkscreen marked pin 1 is GND here but it should be AN (as per mikroBus specifications):
To confirm this issue you can use a mikroBus shuttle board and cable as shown below:
If you check the continuity between board ground and GND on shuttle board you will see that they are not connected but if you check the continuity between AN pin on shuttle board and system ground you will see a direct connection which is wrong.
Solution
Easy solution
We keep things as they are and just update the assembly procedure to place the connector in reverse and update the silkscreen as per the proper placement of the connector.
Actual solution
We update the schematic and layout.