From e9dad8844f8448d1f75a5776408d0d2a86febda8 Mon Sep 17 00:00:00 2001
From: "Mark A. Yoder" <Mark.A.Yoder@Rose-Hulman.edu>
Date: Wed, 7 Jun 2023 12:59:15 -0400
Subject: [PATCH] Switched 22 k to 22k
---
books/beaglebone-cookbook/02sensors/sensors.rst | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/books/beaglebone-cookbook/02sensors/sensors.rst b/books/beaglebone-cookbook/02sensors/sensors.rst
index d36c86d9..3b8b1620 100644
--- a/books/beaglebone-cookbook/02sensors/sensors.rst
+++ b/books/beaglebone-cookbook/02sensors/sensors.rst
@@ -370,7 +370,7 @@ as shown in :ref:`sensors_ultrasonic_fig`. The device outputs ~6.4 mV/in when po
Wiring the LV-MaxSonar-EZ1 Sonar Range Finder to the *P9_33* analog-in port
-:ref:`sensors_ultrasonicRange_code`
+:ref:`py_ultrasonicRange_code`
shows the code that reads the sensor at a fixed interval.
.. _py_ultrasonicRange_code:
@@ -418,7 +418,7 @@ pulse width on the *Echo* output. The width of the pulse tells you the distance.
To make this recipe, you will need:
* Breadboard and jumper wires.
-* 10 k and 20 k resistors
+* 10k and 20k resistors
* HC-SR04 Ultrsonic Range Sensor.
Wire the sensor as shown in :ref:`sensors_hc-sr04_fig`.
@@ -658,7 +658,7 @@ sensor that uses a standard |I2C|-based serial protocol.
To make this recipe, you will need:
* Breadboard and jumper wires.
-* Two 4.7 k resistors.
+* Two 4.7k resistors.
* TMP101 temperature sensor.
Wire the TMP101, as shown in :ref:`sensors_i2cTemp_fig`.
@@ -867,7 +867,7 @@ You can wire it to any GPIO port.
To make this recipe, you will need:
* Breadboard and jumper wires.
-* 4.7 k resistor
+* 4.7k resistor
* DS18B20 1-wire temperature sensor.
Wire up as shown in :ref:`sensors_1-wire_fig`.
--
GitLab