From b308da66b48d2b53786b6f50f30d99bb3087dc37 Mon Sep 17 00:00:00 2001
From: "Mark A. Yoder" <Mark.A.Yoder@Rose-Hulman.edu>
Date: Wed, 7 Jun 2023 12:40:51 -0400
Subject: [PATCH] Switched to py. Added subsubsections
---
books/beaglebone-cookbook/02sensors/sensors.rst | 13 +++++++++----
1 file changed, 9 insertions(+), 4 deletions(-)
diff --git a/books/beaglebone-cookbook/02sensors/sensors.rst b/books/beaglebone-cookbook/02sensors/sensors.rst
index 21dd598d..3fafeb19 100644
--- a/books/beaglebone-cookbook/02sensors/sensors.rst
+++ b/books/beaglebone-cookbook/02sensors/sensors.rst
@@ -150,7 +150,7 @@ To make this recipe, you will need:
* Breadboard and jumper wires.
* Pushbutton switch.
-* Magnetic reed switch.
+* Magnetic reed switch. (optional)
You can wire up either a pushbutton, a magnetic reed switch,
or both on the Bone, as shown in :ref:`js_pushbutton_fig`.
@@ -163,7 +163,7 @@ or both on the Bone, as shown in :ref:`js_pushbutton_fig`.
Diagram for wiring a pushbutton and magnetic reed switch input
-The code in :ref:`js_pushbutton_code`
+The code in :ref:`py_pushbutton_code`
reads GPIO port *P9_42*, which is attached to the pushbutton.
.. _py_pushbutton_code:
@@ -182,12 +182,12 @@ reads GPIO port *P9_42*, which is attached to the pushbutton.
:download:`pushbutton.js <../code/02sensors/pushbutton.js>`
-Put this code in a file called *pushbutton.js* following the steps in :ref:`sensors_getting_started`.
+Put this code in a file called *pushbutton.py* following the steps in :ref:`sensors_getting_started`.
In the VSC *bash* tab, run it by using the following commands:
.. code-block:: bash
- bone$ ./pushbutton.js
+ bone$ ./pushbutton.py
data = 0
data = 0
data = 1
@@ -274,7 +274,11 @@ To make this recipe, you will need:
- Flex resistor (optional)
- 22k resistor
+.. todo
+ Convert to Omega
+
A variable resistor with three terminals
+^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
:ref:`sensors_analogIn_fig` shows a simple variable resistor (trimpot)
wired to the Bone. One end terminal is wired to the ADC 1.8 V power supply on pin *P9_32*,
@@ -314,6 +318,7 @@ Add the code to a file called _analogIn.js_ and run it; then change the resistor
outputs a value between 0 and 4096.
A variable resistor with two terminals
+^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Some resistive sensors have only two terminals, such as the flex sensor in :ref:`sensors_flexResistor_fig`
The resistance between its two terminals changes when it is flexed.
--
GitLab